Eneo VKCD-1338 User Manual download pdf (Page 41)

1. Safety Instructions

• Read these safety instructions and the operation manual ﬁrst before you install and commission the camera.

• Keep the manual in a safe place for later reference.

• Protect your camera from contamination with water and humidity to prevent it from permanent damage.

Never switch the camera on when it gets wet. Have it checked at an authorized service center in this case.

• Never operate the camera outside of the speciﬁcations as this may prevent the camera functioning.

• Do not operate the cameras beyond their speciﬁed temperature, humidity or power ratings.

• Operate the camera only at a temperature range of -10°C to +50°C and at a humidity of max. 80%.

• To disconnect the power cord of the unit, pull it out by the plug. Never pull the cord itself.

• Pay attention when laying the connection cable and observe that the cable

is not subject to heavy loads, kinks,

or damage and no moisture can get in.

• Do not attempt to disassemble the camera board from the dome.

• The warranty becomes void if repairs are undertaken by unauthorized persons.

Do not open the camera housing.

• Never point the camera towards the sun with the aperture open. This can destroy the sensor.

• Installation, maintenance and repair have to be carried out only by authorized service centers.

Before opening the cover disconnect the unit from mains input.

• Contact your local dealer in case of malfunction.

•

Only use original parts and original accessories from Videor E. Hartig GmbH.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 75 76

No comments

Eneo VKCD-1338 User Manual Page 41